Misuses Of Fume Purifier

Misuses 1: the greater the suction, the better fume extractor
The greater the suction, the greater the power consumption, and the noise will be increased, so the suction should be appropriate to the use interface! Not the bigger the better!

Misuse 2: the higher the filtration rate, the better smoke extractor
High filtration rate itself is not bad, the problem is based on the using environment, if there is any need to achieve a very high filtration rate? For example, the operating room or laboratory has a very high demand for the cleanliness of air: but in the factory workshop, there is no need to use the high “filtration rate” like the hospital operating room.
The higher the “filtration rate”, the more sophisticated the filtration system will be, and the greater the air resistance, so the higher the cost will be.

Misuse 3: the greater power, the better air extractor
The greater the power, the larger the noise will be, the more energy consumption, the higher the price will be. According to the using situation, choosing the appropriate power, using independent high efficiency, low power motor, although the power is small. the suction is not small.

Misuse 4: the more the air flow, the better dust extractor
Industrial purifiers focus mainly on negative pressure (when negative pressure is high, the suction force is greater), not the air flow. Even though the air flow is large, it may not necessarily in great suction force.

Misuses 5: Imported fans must be good
In the aspects of manufacturing processes and quality monitoring, imported fans may be better than the domestic fans, but the price will be higher. Under the condition of ensuring the normal operation of the purifier, there are a lot of domestic fans with high quality and high cost performance. For example, the motor of our purifier can achieve low power, high speed, long life, zero maintenance and other characteristics.

Misuse 6: The lower of the replacement frequency of filter core, the better

Under the premise of ensuring suction force and filtration effect, the lower the frequency of replacement, the better. However, the filter core has rated saturation, if the fume volume in site is greater, so the saturation of filer core failure will be faster, that is, the frequency of replacement must be higher. This is inevitable, and it depends crucially on the environmental conditions. If the filter is saturated and blocked without replacement, it must results in the suction force reduction, the filtration will not e completer so that the environment will be polluted.