Home
>
Products
>
Automatic Screw Feeders
>
|
| Place of Origin | China |
| Brand Name | waterun |
| Certification | CE |
| Model Number | Waterun-900D |
Auto Screw Feeder Driver Conveyor System Screw Counting Function Stainless Steel
Product Detail:
Technical Details:
| Model | Waterun-900D | |
| DC power supply | AC220V, DC12V 500MA, AC Adapter | |
| Applicable screw length(under head) | Up to 20mm | |
| Rail adjustment range | M1.0-M5.0 | |
| Speed of picking up | 1.5 sec/piece | |
| Product size | 180 x 125 x 150mm | |
| Weight | About 3kg | |
Introduction:
Problems and solutions :
| Malfunction | Reason | Solutions |
| Screw Feeder can't work | 1:Power supply broken,2:Switch is broken | Replace the broken part |
| Power indicator is on,but the machine can't work |
1:Front/back sensor block the signal； 2:The motor power cable is cut |
1:check and adjust 2:Rewelding the wire |
| Screw stuck in rail | Up and down brush . The gap between the rail or the position of high limited plate is wrong . | Making the adjustment after checking |
| Dropping the screw | The up/bottom adjust plate didn't installed very well | Adjust the position of the adjusting plate . |
| Vibrating all the time |
1:The speed of vibration is too big , and the setting delayed time is to long ； 2:Front/ back sensor was in the wrong place |
Making the adjustment. |
| It is too slow to give out the screws . |
1:The screw feeder was put on the unflat place； 2:The speed of vibration is too small ； |
1:Re-adjust the angle of the rail ; 2:Adjust the speed of giving the screws .； 3:Lengthern the time of delivering and giving the screws . |
Contact Us at Any Time
